Buttons:

Button 1: (on the back, left)

Press to toggle display mode (hh:mm/:ss) Hold to enter menu.

Button 2: (on the back, right)

Button 3: (on the top)

Use this button to toggle the alarm on/off. There is an orange LED inside the enclosure that lights up when the Alarm is on.

Normal Operation

During normal operation, the controls and indicators are used as follows:

Button 1: Press and hold to enter setting modes.

Hold for 1 second, and you will hear one beep. Release the button to enter alarm setting mode.

Hold for 2 seconds, and you will hear another beep. Relase the button to enter time setting mode.

Hold for 3 seconds or more, and you will hear a third beep. Release the button to enter the menu system. The menu system is used to set minor settings such as 12/24 hour time, colon indicator options etc.

Alarm and Time setting Mode

Alarm and time setting mode works identically, see the previous second for how to enter each mode.

When you enter alarm or time setting mode the current alarm setting or time setting will show up in the display. The first two digits will blink.

While the two first digits are blinking, rotate the encoder to set hours. Once you are finished, press the button. The two last digits will start blinking.

While the two last digits are blinking, rotate the encoder to set minutes. Once you are finished, press the button. The display will now show seconds blinking.

While the seconds are blinking (two last digits with nothing shown for the two first digits), rotate the encoder to set seconds. Once you are finished, press the button.

The display will now remember your alarm or time setting and return to normal operation.

Menu system

The menu system is used to set various minor options for the clock.

Since the clock can only display digits, the menu uses numbers to indicate options.

Each menu item is numbered, starting from 1. The two leftmost digits are used to indicate each menu item number.

For each menu item, the selections are numbered, refer to each menu item below for details. The two rightmost digits are used to indicate the menu item.

Rotate the encoder knob to select between 12 and 24 hour time viewing.

Keep the following in mind when the clock is in 12 hour mode:

  • The right orange indicator LED will be used to indicate AM/PM. It will light up when it is PM.
  • Setting time and alarm is always done using 24-time. For example, to set the time to 4PM, set it to 16:00.

Option 0 - always off Option 1 (default) - always on) Option 2 - blinking

Option 0 - off (default) Option 1 - on

Allows you to turn the sound the clock makes when it is turned on on and off

Option 0 - off Option 1 (default) - on

Allows you to set the tubes to turn off during the night.

Option 0 (default) - off Option 1 - The tubes will turn off between 01:00 and 06:30

When nixie tubes are set to display the same number for a long period of time there is a chance of display damage (referred to as cathode poisoning). The chance of this happening is low for this clock since it uses multiplexing meaning that only one digit is ever turned on at a time.

Option 0 - off Option 1 (default) - on. The clock will display various digit rotation effects every few minutes.

Turns GPS on/off. Requires that a GPS module is connected (not included)

Option 0 - off Option 1 - on

Sets the time zone for GPS, hours. The counter goes from -12 to 12. For negative numbers, the dots will illuminate.

Sets the time zone for GPS, minutes. For most time zones, this is zero.

Sets Daylight Savings on/off

Option 0 - off Option 1 - on