Simpleclock usage instructions

The clock is controlled using two buttons and a slide switch. the two buttons are on the top-right and the slide switch on the right side.

Alarm Switch

The position of the alarm slide switch determines the function of the alarm. When it is set in the UP position, the alarm is ON. When set in the DOWN position, the alarm is OFF.

The rightmost dot on the display lights up when the alarm is on

Setting the clock

To set the clock, first make sure the slide switch is set to the DOWN (alarm OFF) position.

Hold both the buttons, the display will show "Time" Release the buttons, and the display will start to blink.

To set the time, use the left button to decrement and the right button to increment. When you hold the button down, the time will increase or decrease at accelerating speed.

To fine tune the minutes, tap each button gently, and the time will change by one minute at a time.

When you are done setting the time, release both buttons and wait for a couple of seconds. When the display stops blinking the new time has been set.

Setting the alarm

To set the alarm, first make sure the slide switch is set to the UP (alarm ON) position.

The setting procedure is the same as for setting the clock.

After you have set the alarm, you can toggle it on and off by changing the position of the slide switch.

Turning off the alarm

When the alarm goes off, it will beep continuously until you press either of the two buttons.

The alarm will automatically go off every 24 hours. To disable the alarm fully, slide the slide switch DOWN (alarm OFF).

Clock Menu

To enter the menu, press the left button.

The menu will cycle through the following items:

BRIT - Set brightness 24H - Toggle 24h/12h clock TEMP - Set temperature mode

To exit the menu, release the button and wait for a few seconds.

Changing the Brightness

Press the left button once. BRIT will be shown in the display. Now press the right button to change the brightness. It will cycle from lowest to highest brightness.

Once you are happy with the brighness setting, release all buttons and wait a few seconds.

Switching between 24h and 12h mode

Press the left button twice. 24H will be shown in the display. Now press the right button to toggle the display mode between On and Off.

Once you are happy with your setting, release all buttons and wait a few seconds.

Note: 12 hour mode is only for display. When setting the clock and alarm, set it in 24 hour mode as normal. After setting is complete, the clock will revert to 12h mode.

Changing the temperature mode

Press the left button three times. The display will show TEMP. Now press the right button to toggle between on and off.

In on mode, the display will toggle between showing time and showing temperature every few seconds.

Changing the Display Mode

To change the display mode, press the right button.

For each press, the clock will cycle between the following modes:

  • Normal mode (24h or 12h clock, seconds are not shown). (in this mode, when TEMP is set to ON, display will toggle between showing the time and the temperature)
  • Seconds mode (shows seconds, as well as AM/PM mode when in 12h mode)
  • Temperature mode (shows current temperature)